Part 1. Overview
10 Design Guide DCM014A51
3. Assigning one group address to a remote controller group:
Figure 6. Assigning One Group Address to a Remote Controller Group
4. Assigning a group address to each indoor unit in a remote controller group:
Figure 7. Assigning a Group Address to Each Indoor Unit in a Remote Controller Group
Note: As shown in the figures above, a remote controller group consists of several
indoor units wired to the same remote controller. A remote controller group consists of
1-16 indoor units that can be started or stopped simultaneously. For units without a
remote controller, each unit is treated as a group.
To Next Page
Loading...
