Daikin SiBE041010 - Removal of PCB; Swing Motor

SiBE041010 Indoor Unit
Removal Procedure 111
1.6 Removal of PCB / Swing Motor
Procedure Warning Be sure to wait 10 minutes or more after turning off all power
supplies before disassembling work.
Step Procedure Points
1. Remove the shield plate. Preparation

Remove the electrical box
according to the “Removal
of Electrical Box”.
1
Unfasten the hooks at
the upper 2 positions of
the shield plate.
2
Unfasten the hook at
the lower position, and
remove the shield plate
(1).
3
Lift the shield plate (2)
and unfasten the 2
hooks.
4
Slide the shield plate
(2) and remove it.
(R8032)
Hook
shield plate (1)
Hook
(R8033)
(R8034)
Hook
Shield plate (2)