RA Indoor Unit SiBE121021_C
156 Operation Manual
Indoor Unit
Model
Mode
COOL
22˚C AUTO
AUTO
25˚C
AUTO
Temperature
setting
Airflow
rate
COOLING
ONLY
HEAT
PUMP
1. Air filter
2. Titanium Apatite Photocatalytic
Air-Purifying Filter:
• These filters are attached to the inside of
the air filters.
3. Air inlet
4. Front panel
5. Panel tab
6. Room temperature sensor:
• It senses the air temperature around the
unit.
7. INTELLIGENT EYE sensor
8. Display
9. Air outlet
10. Horizontal blades (flaps)
11. Vertical blades (louvers):
• The louvers are inside of the air outlet.
12. Indoor Unit ON/OFF switch
• Push this switch once to start operation.
Push once again to stop it.
• The operation mode refers to the following
table.
• This switch is useful when the remote
controller is missing.
13. Operation lamp (green)
14. TIMER lamp (yellow)
15.
INTELLIGENT EYE lamp (green)
16. Signal receiver:
•
It receives signals from the remote controller.
• When the unit receives a signal, you will
hear a short beep.
• Operation start ........beep-beep
• Settings changed.....beep
• Operation stop..........beeeeep
To Next Page
Loading...