Service Check Function SiUS12-928_A
95 Service Diagnosis
Check Method 2
1. Press the 3 buttons (TEMP, TEMP, MODE) at the same time.
The left-side digit blinks.
2. Press the TEMP
or button and change the figure until you hear the sound of beep or beep-
beep.
3. Diagnose by the sound.
beep: The left digit does not correspond with the error code.
beep beep: The figure of the left digit corresponds with the error code but the one’s not.
long beep : Both the left and right digits correspond with the error code. (
→ See 7.)
4. Press the MODE button.
The right-side digit blinks.
To Next Page
Loading...
