Daintree WAC60 - Page 2

Conguration GuideDaintree
®
Wireless Area Controller (WAC60)
1 2
Installation Process (continued) Connect WAC to Operational Network
9. Click on the Conguration -> System Controller menu:
• Enter the hostname or IP address of your
System Controller from the deployment options worksheet.
• If the network requires the use of proxies to obtain internet
   access,entertheHTTP,HTTPSandSOCKSproxyserver 
   information.Formostprojects,thisinformationisnot 
required.
• Press Save.
10. IfDHCPaddressingistobeused,nofurther
 congurationisrequired.
11. IfstaticIPaddressingistobeused,clickonthe
Conguration -> Network Interfaces menu:
• Edit the network interface.
• Enter the network parameters from the deployment options
worksheet and press Save & Apply.
• Do not wait for the “Waiting for the changes to be
applied…” dialog to complete.
12. Remove power from the WAC.
1. Disconnect the Ethernet cable between the WAC and laptop.
2. Connect the WAC to the operational network.
3. Apply power to the WAC.
4. Check the WAC status LEDs. When it can communicate with
 theSystemController(SC),thestatusLEDsturnsolidgreen.
 Thisshouldoccurwithin5minutes.IfthestatusLEDsareorange,
the WAC cannot communicate with the SC.
Note: The WAC may be upgraded when it connects to the SC.
Ifso,thestatusLEDswillshowtheupgradingpatternasdescribed
in the WAC install guide before showing solid green or orange.
Theseinstructionsdonotpurporttocoveralldetailsorvariationsinequipmentnortoprovideforeverypossiblecontingencytobemetinconnectionwithinstallation,operation
ormaintenance.Shouldfurtherinformationbedesiredorshouldparticularproblemsarisewhicharenotcoveredsufcientlyforthepurchaser’spurposes,themattershouldbe
referredtoGECurrent,aDaintreecompany.
Questions:
Web: gecurrent.com/daintree
Phone: 1-866-855-8629
Email: daintree.support@gecurrent.com
www.gecurrent.com
©2021CurrentLightingSolutions,LLC.Allrightsreserved.GEandtheGEmonogramaretrademarksofthe
General Electric Company and are used under license. Information provided is subject to change without notice.
All values are design or typical values when measured under laboratory conditions.
DT118 (Rev. 07/08/2021
CAUTION
RISK OF EXPOSURE IF BATTERY IS REPLACED BY AN
INCORRECT TYPE. DISPOSAL OF USED BATTERIES ACCORDING
TO THE INSTRUCTIONS
WAC60