Need help?Do you have a question about the DAITEM DP8000 Series and is the answer not in the manual?
Procedures for opening the universal transmitter and affixing the guarantee label.
Instructions for connecting the lithium block and re-powering the transmitter.
Steps to program the installation code using keys and micro-switches.
Configuring channel/zone, operating mode, contact type, and sensor type.
Guidelines for selecting and connecting integral and external contacts (NC/NO).
Procedures to verify power, operating mode, contact/sensor type, and radio link.
Guidance on connecting contacts using serial or parallel wiring.
Instructions for mounting the transmitter and fitting the integral contact and door magnet.
Details for surface/flush mounting external wired contacts D8923, D8931, D8932.
Installation of D8924 screw terminals and D8922 floor mount contacts.
Installation procedures for wide gap, glass break, and pressure mat sensors.
Guidance on locating and installing roller shutter sensors.
Detailed steps for fixing the roller shutter sensor inside the casing.
Procedures for testing transmitter operation and contact states.
How to test the shutter's movement detection functionality.
How the DP8360 panel signals low battery or radio link loss.
General| Frequency | 868 MHz |
|---|---|
| Power source | Battery |
| Frequency Range | 868.0 - 868.6 MHz |
| Modulation | FSK |
| Output Power | 10 dBm |
| Supply Voltage | 3 V |
| Operating Temperature | -10°C to +55°C |
To Next Page
