Dakota GPS-50-2 - User Manual

1 MAN #650519C
GPS-50-2
GPS Speed and Bus Interface Module
Your new GPS-50-2 includes:
Table of Contents:
Product Overview
Page 2
Installation: Wiring Overview
Page 3
Installation: Wiring using a BIM cable (no BIM-01-2 present)
Page 4
Installation: Wiring standalone (individual gauge, or BIM-01-2 present)
Page 5
Installation Overview
Page 6
Setup / Clock Setup: VFD3 or VFD3X without a BIM-01-2
Page 7
Setup / Clock Setup: VHX without a BIM-01-2
Page 8
Setup / Clock Setup: HDX or RTX without a BIM-01-2
Page 9
Setup: Standalone speed output only
Page 10
Setup: Calibration setups for standalone speed only
Page 11
Cruise Operation
Page 13
Setup: GPS-50-2 Menu Options
Page 14
Troubleshooting / Quick tips
Page 18
Service / Warranty
Page 20
IMPORTANT NOTE!
• When using to operate a cruise control, see the special mounting requirements
on the bottom of page 13.
• The GPS-50-2 cannot connect to a BIM-01-2 series.
o The two units cannot send similar data at the same time.
GPS module
394192 - BIM-XX-2 interface harness
Optional Remote
antenna, part 600041.
Contact Dakota Digital
Sales to order.

Dakota GPS-50-2 Specifications