Daktronics OMNISPORT 2000 - Pre-Game Operations

Water Polo Mode Operation, Menus, & Settings
106
Edit Player
Press [EDIT PLAYER •] to adjust the number of penalties that have been assigned to a
player. Input the player number to adjust and press [ENTER]. The player and current
number of penalties will be displayed on the right LCD. Use the numeric keypad to input
the correct number of penalties for that player and press [ENTER].
Delete Penalty
Press [DELETE PENALTY •] and the LCD for that team will show (→) next to the penalty
time. If there is more than one penalty time counting for that team, use [↑][↓] to select
which penalty needs to be deleted. Press [ENTER] to delete the penalty or press [CLEAR]
to exit without deleting the penalty.
Clear All Penalties
Press [CLEAR ALL PENALTIES •]>[ENTER] to remove all penalties that are currently being
counted for that team.
Pre-Game Operations
Complete the following steps before each game.
1� Set up and test the system. Turn on the timer. Enter the correct date and time, and
then select the proper sport operation.
2� Print out the consoles settings by pressing [MENU]>[2]>[1]>[ENTER] and verify they are
correct. Specically review:
• Horn Control – Refer to Horn Control (p.111).
• Shot=0 Control – Refer to Shot=0 Control (p.111).
• Default Time Set – Refer to Set Times (p.109).
• Auto Sequence is ON or OFF. Refer to Auto Sequence (p.110).
If the Auto Sequence is set to ON, the console will:
a� Count Period 1 time down to zero.
b� Switch to Rest 1 time and start counting. Count down to zero.
c� Switch to Period 2 and reset time to period time. Wait for start.
d� Operator presses [START].
e� Count Period 2 time down to zero.
f� Switch to Rest 2 time and start counting down to zero.
g� Switch to Period 3 and reset time to period time. Wait for start.
h� Operator presses [START].
i� Count Period 3 time down to zero.
j� Switch to Rest 1 time and start counting down to zero.
k� Switch to Period 4 and reset to period time. Wait for start.
l� Operator presses [START].
m� Count Period 4 time down to zero.
n� Switch to Rest 2 time and start counting. Count down to zero.
o� Switch to Period 5 and reset to overtime. Wait for start.