Daktronics OMNISPORT 2000 - Updating Software in the Console

General Console Features & Operation
21
Basic Operation of Radio Settings
Display Action
The LCD will toggle between
these 2 screens.
RADIO SETTINGS
BCAST X CHAN YY
ENTER TO ACCEPT
CLEAR TO MODIFY
BCAST GROUP X*
RADIO CHAN YY
X = broadcast group number
YY = channel number
The LCD shows the current radio settings along with a prompt to
accept or modify these values.
If the radio settings are correct press [ENTER].
If these values are incorrect, press [CLEAR], and the LCD at
bottom left is shown, allowing edit of the channel or broadcast
group setting.
Use the number keys to enter the desired broadcast group and
press [ENTER] to accept. The asterisk will move to the channel
setting.
Edit the channel number to the desired value and press [ENTER]
to accept.
Broadcast
Group
Channel
Setting
Control Scoreboards
0 0 All Scoreboards
1
0 All in BCAST Group 1
1-8
Set to corresponding BCAST 1
Channel
8*
0 All in BCAST Group 8
1-8
Set to corresponding BCAST 8
Channel
* Gen V radio receivers have only 4 groups; also, on broadcast
groups 2 and 4, only channels 1-4 may be used.
Updating Software in the Console
Equipment needed:
• OmniSport 2000 timing console
• 9-pin male to 9-pin female cable, Daktronics part # W-1267 (in maintenance kit) or
Radio Shack part # 27-117
• Computer with an available serial (COM) port; or a USB-to-serial adapter
• Computer with Internet connection