Daktronics OMNISPORT 2000 - Clear Order; Delete Event; Print Menu; Print Race Results

Swimming Mode Menus & Settings
45
When to use this:
• If an event was missed and not programmed into the original event order.
• An additional event was added, like a time trial, and needs to be placed into the
event order.
Delete Event
This menu is used to remove an event from the event order
list.
DELETE INDEX
#001* E:001 R:P
From Main Menu – [2]>[2]>[3]
Use [↓][↑] to select the event location number to be deleted. Press [ENTER] to delete the
location number shown.
When to use this:
• If an extra event was programmed into the original event order.
Clear Order
This menu is used to completely erase the entire event order
stored in the OmniSport 2000 console. Use with caution�
MENU-EVENT ORDER
CLEAR ORDER? Y/N
From Main Menu – [2]>[2]>[4]
Press [YES] to clear the entire event order and exit the menu. Press [NO] to exit the menu
and leave the event order as is.
When to use this:
• If the existing event order needs to be completely erased from memory in the
OmniSport 2000 console so a new event order can be programmed from scratch.
Remember: the operator may scroll through the sub-menus using [↓][↑] and [ENTER]. From
this point on, the manual uses the number sequence to navigate through the menus.
Print Menu
The Print Menu allows the operator to print a specic race
result, the current event order in the OmniSport 2000 console,
or the settings for the current console conguration.
Print Race Results
This menu is used to print races that are stored in the
OmniSport 2000 console’s revolving race memory. Refer
to Revolving Race Memory if Pro Software Is Connected
(p.40) for more information. Each time the console times
a race, that race is assigned a race number. The race number increments by one each
time a new race is started and counts up from 1 to 999. When the console gets to race
number 999, it rolls over and the next race number is 1. The console has enough memory
to store approximately the last 50 races. If the memory in the console is full and a new
race needs to be stored, the console deletes the oldest race in its memory.
MENU-EVENT ORDER
3-DELETE EVENT
From Main Menu – [2]>[2]>[↓]>[↓]
MENU-EVENT ORDER
4-CLEAR ORDER
From Main Menu – [2]>[2]>[↓]>[↓]>[↓]
MENU-MAIN
3-PRINT MENU
MENU-PRINT
1-RACE RESULTS
From Main Menu – [3]