Daktronics OMNISPORT 2000 - Setup Timer Menu

Swimming Mode Menus & Settings
48
Lane Label
This menu labels the lanes either 1–10 or 0–9.
MENU-POOL
LANE LABEL:1-10*
From Main Menu – [4]>[1]>[4]
Some facilities have ten lanes, but only want to utilize the center 8 lanes for a particular
event or only for nals. By setting the label 0–9, the center 8 lanes are automatically
numbered 1–8.
The only thing that needs to be reviewed is the numbers on the blocks.
Use [←][→] to toggle the setting from 1–10 or 0–9 and then press [ENTER] to save.
Setup Timer Menu
This menu contains the settings that tell the console which
inputs to use, how to read those inputs and what to do with
those inputs.
Start Input
The console can be congured to receive inputs from
different starting devices. Some start devices are an open
switch that closes (Normally Open) and others are a closed
switch that opens (Normally Closed).
MENU-TIMER
START IN: N.O.*
From Main Menu – [4]>[2]>[1]
Typically, plug the start cable into the START (N/O) jack on the HS-200 horn start and
plug the other end of the start cable into J12 on the OmniSport 2000 console. When this
connection is used, verify that the OmniSport 2000 console is set to N.O. (Normally Open).
The advantage of using N.O. is that two HS-200 horn starts, one on the near end of the
pool and one on the far end of the pool, can both be connected in parallel to the
OmniSport 2000 console’s start input. This eliminates the need to move the horn start
during the middle of the event.
Use [←][→] to select between N.O. or N.C. and then press [ENTER] to save.
Horn Start Manufacturers Type of Output(s)
Daktronics (HS-200) N.O. and N.C.
Colorado Timing Systems N.O.
Omega N.C.
MENU-POOL
4-LANE LABEL
MENU-SETUP
2-TIMER
MENU-TIMER
1-START IN
From Main Menu – [4]>[2]