Daktronics OMNISPORT 2000 - Show; Show Start; Show Place; RTD Offset

Swimming Mode Menus & Settings
55
Use [←][→] to select YES or NO. If the timer is set to YES, the display shows subtractive splits
and then shows the cumulative splits. Press [ENTER] to save.
Note: It is important for the timer operator to explain this to coaches before the meet.
Show DQ
This menu congures what will show on the display when
there is a disqualication (DQ).
SHOW DQ
STATUS=DQ ONLY*
From Main Menu – [4]>[3]>[2]>[6]
SHOW DQ
STATUS=DQ/TIME*
Use [←][→] to select to display the DQ ONLY (in the TIME eld) or to display the DQ/TIME,
with “DQ” in the PLACE eld and the time in the TIME eld. Press [ENTER] to save.
Show Start
This menu tells the console whether or not to display the start
reaction time (from RTOPs) on the display.
SHOW START
REACTION=NO *
From Main Menu – [4]>[3]>[2]>[7]
SHOW START
REACTION=YES*
Use [←][→] to select NO (do not show start reaction time) or YES (show start reaction
time) and then press [ENTER] to save.
Show Place
This menu determines whether or not to display place with
split times.
SHOW PLACE
FOR SPLITS= NO *
From Main Menu – [4]>[3]>[2]>[8]
SHOW PLACE
FOR SPLITS= YES*
Use [←][→] to select YES or NO. If the timer is set to YES, the display shows the swimmer’s
place and split time. Press [ENTER] to save.
RTD Offset
This menu will add an offset to the Real-Time Data (RTD)
output to the matrix display.
MENU-RTD/MATRIX
RTD OFFSET: 5K*
From Main Menu – [4]>[3]>[2]>[9]
Use [↑][↓] to toggle through the RTD offset settings (0K, 5K, 10K, or 15K). Each setting adds
5000 to the original item numbers, up to 15000. The default setting is 0K (no offset).
To save the setting, press [ENTER].
When to use this:
• Data from more than one pool/OmniSport 2000 is going to one display.
• If using a Daktronics M2, M3, or V-Link
®
controlled display, this menu allows multiple
RTD inputs directly into the display.
MENU-RTD/MATRIX
6-SHOW DQ
MENU-RTD/MATRIX
7-SHOW START
MENU-RTD/MATRIX
8-SHOW PLACE
MENU-RTD/MATRIX
9-RTD/OFFSET