Daktronics OMNISPORT 2000 - Setup Network Menu

Swimming Mode Menus & Settings
58
Number of Copies
PRINT COPIES
NUMBER 1-5: 1*
From Main Menu – [4]>[5]>[5]
Press the [1]–[5] keys to select the number of copies to print and press [ENTER] to save.
Intensity
This menu sets the printer’s contrast for easy readability.
The typical level is 5.
PRINT INTENSITY
LEVEL 1-5: 5*
From Main Menu – [4]>[5]>[6]
Press the [1]–[5] keys to select the print intensity and press [ENTER] to save.
Setup Time-of-Day Menu
This menu is used to set the console’s date and time.
DATE MM/DD/YY
TOD HH:MM:SS*
From Main Menu – [4]>[6]
Press the [0]–[9] keys to enter the correct date and time and then press [ENTER] to save.
Press [CLEAR] twice to exit without saving and retain the previous time and date.
Setup Network Menu
This menu is used to congure various network settings for
outputting Real-Time Data (RTD) to displays and connecting
to Pro Swimming and Meet Manager software.
Network Enable
This menu sets the ETHERNET jack output on or off. If the jack
is not needed, it can be turned OFF (default).
MENU-NETWORK
NETWORK: ON *
From Main Menu – [4]>[7]>[1]
MENU-NETWORK
NETWORK: OFF*
Use [←][→] to toggle between ON/OFF and then press [ENTER] to save.
Note: If this setting is set to OFF, all of the menus below will be disabled.
IP Address
This menu allows the operator to set or verify the IP address
of the console. The default setting is shown below.
1-STD* 2-CUST
192.168. 0. 55
From Main Menu – [4]>[7]>[2]
MENU-PRINTER
5-# OF COPIES
MENU-PRINTER
6-INTENSITY
MENU-SETUP
6-TIME OF DAY
MENU-SETUP
7-NETWORK
MENU-SETUP
1-NETWORK ENABLE
MENU-NETWORK
2-IP ADDRESS