Daktronics VIP-5000 Series - Page 3

VIP-5000 Series Quick Guide
DD2773153
Rev 06
30 January 2018
Page 3 of 6
201 Daktronics Drive
Brookings, SD 57006-5128
www.daktronics.com/support
800.325.8766
2. Launch the DisplayFind application by double-clicking the DisplayFind icon.
Refer to Figure 12.
3. Connect to the display using the DisplayFind utility.
a. Select the appropriate Network Adapter.
b. Click Find Displays to detect displays. Refer to Figure 13.
Figure 13: Daktronics DisplayFind Application
c. Click the desired display to launch the conguration utility within a web browser.
Note: If multiple displays are found, use the IP address or name to conrm the identity of the
correct display.
Logging in to the Processor
1. Navigate to http://<IPaddress>:<Port>. The port is typically 85.
2. Type Dak into the User name text box. Refer to Figure 14.
3. Type DakPassword! into the Password text box.
4. Click OK.
These are the factory-congured login credentials. Daktronics
strongly recommends changing the password after initial conguration.
After setting a new password, this new password must be entered into the Password text box
during login.
Note: Do not lose the password; losing it may require a service call.
Newer display-mount VIP-5160s have an internal reset switch that can be used to reset the password
and/or conguration. Remove the switch cover to access the reset switch and press down for 5-15
seconds. The user name and password will revert to the factory-congured login credentials.
Note: Use caution when using an internal reset switch. Pressing the switch for longer than 15 seconds
can reset the conguration.
Figure 12: DisplayFind Icon
Figure 14: VIP-5000 Series Login