228 • Operational Reference Nano Series GigE Vision Camera
GigE Vision Transport Layer Control Category
The Genie Nano GigE Vision Transport Layer control, as shown by CamExpert, has parameters used
to configure features related to GigE Vision specification and the Ethernet Connection. Parameters
in gray are read only, either always or due to another parameter being disabled. Parameters in
black are user set in CamExpert or programmable via an imaging application.
Features listed in the description table but tagged as Invisible are usually for Teledyne DALSA or
third party software usage—not typically needed by end user applications. Also important, Genie
Nano cameras are available in a number of models implementing different sensors and image
resolutions which may not support the full feature set defined in this category.
GigE Vision Transport Layer Feature Descriptions
The following table describes these parameters along with their view attribute and minimum
camera firmware version required. Additionally the Device Version column will indicate which
parameter is a member of the DALSA Features Naming Convention (denoted by DFNC), versus the
GenICam Standard Features Naming Convention (SFNC tag is not shown).
The Device Version number represents the camera software functional group, not a firmware
revision number. As Genie Nano capabilities evolve the device version tag will increase, therefore
identifying the supported function package. New features for a major device version release will be
indicated by green text for easy identification.
To Next Page
Loading...
