12 Pantera 1M60 and 1M30 User’s Manual
DALSA 03-032-10033-09
2.2 Input/Output
Figure 6: Camera Inputs/Outputs
2.3 LED Status Indicator
Table 3: Status LED
Color of Status LED Meaning
Flashing Green Camera Initialization
Solid Green Camera Ready
Flashing Red Fatal Error
Solid Red Warning, such as firmware did not load or voltage out of
limit
2.4 Connectors
The camera uses a:
• high-density 26-pin MDR26 connector for Camera Link control signals, data signals,
and serial communications. Refer to
Figure 7: MDR26 Connector for pin descriptions.
• 6-pin Hirose connector for power. Refer to section 2.4.2 Power Connector, for pin
descriptions.
2.4.1 Camera Link Data Connector
The Camera Link interface is implemented as a Base Configuration in the Pantera 1M60
and 1M30 cameras. A Base Configuration uses 1 MDR26 connector and 1 Channel Link
chip. The main characteristics of the Base Configuration are:
• Ports supported: A, B, C
• Serializer bit width: 28
• Number of chips: 1
• Number of MDR26 connectors: 1
To Next Page
Loading...
