Dalsa Spyder 3 GigE SG-10-01k80-00-R - A4.5 Camera Frequency Measurement; A4.6 Returning the LED Status

Spyder 3 GigE User’s Manual
DALSA 03-032-10158-09
89
A4.5 Camera Frequency Measurement
Purpose: Returns the frequency for the requested Camera Link control
signal
Syntax:
gsf i
Syntax Elements:
i
Camera Link control signal to measure:
1: CC1 (EXSYNC)
2: CC2 (PRIN)
3: CC3 (CCD Direction)
4: CC4 (Spare)
Note:
• Camera operation may be impacted when entering the gsf
command (i.e., poor time response to direction change or
video may have artifacts (gain changes) for several lines
while the camera returns signal information)
• This command is not available when operating the camera
with external CCD direction control (scd 2)
Example:
gsf 1
A4.6 Returning the LED Status
Purpose: Returns the status of the camera’s LED.
Syntax:
gsl
The camera returns one of the following values:
1 = red (loss of functionality)
2 = green (camera is operating correctly)
5 = flashing green (camera is performing a function)
6 = flashing red (fatal error)
Notes:
• Refer to section 295H2.5 Camera LED for more information on
the camera LED