danalock V3 - Supported Command Classes; Node Info; Association CC V2 (secure); Battery CC V1 (secure & unsecure)

2 | P a g e
Supported Command Classes
Command Class
Version
Not added
Non-Secure
added
Securely added
Non-secure
CC
Secure CC
Z-Wave Plus Info
2
Support
Support
Support
Transport Service
2
Support
Support
Support
Security 0
1
Support
Support
Support
Security 2
1
Support
Support
Support
Association
2
Support
Association Grp Info
1
Support
Battery
1
Support
Configuration
1
Support
Device Reset Locally
1
Support
Door lock
2
Support
Firmware update MD
4
Support
Manufacturer Specific
2
Support
Notification
8
Support
Power level
1
Support
Superversion
1
Support
Version
2
Support
Node Info
Generic Device Class
0x40 GENERIC_TYPE_ENTRY_CONTROL
Specific Device Class
0x03 SPECIFIC_TYPE_SECURE_KEYPAD_DOOR_LOCK
Association CC V2 (secure)
Associations Groups
Group 1 is Lifeline. All unsolicited reports are sent to the node in Lifeline. The Danalock can send the following
commands through Lifeline:
ID
Name
Node Count
Description
1
Lifeline
1
Supports the following command classes:
• Device Reset Locally: triggered upon reset.
• Battery/notification: triggered upon low battery.
• Door Lock operation report: triggered upon a change in door lock
• Notification: triggered upon a change in door lock
Battery CC V1 (secure & unsecure)
The Battery Get request can be used to get the status of the battery. To get a useful battery level the motor of
the lock should be operated at least once for the lock to sample a meaningful battery level. When battery
level is low a battery warning is send to the controller.