danalock V3 - Page 4

4 | P a g e
Firmware Update Meta Data CC V4 (secure)
The Danalock supports firmware update of the Z-Wave module over the air.
The firmware upgrade takes ~30 min with S0 and ~20 min with S2.
Firmware ID = 0x0A01.
Firmware 0 ID = 0x0000.
Manufacture Specific CC V2 (secure & unsecure)
Value
Comment
Manufacturer ID
0x010E
Poly-control
Product Type ID
0x0009
Danalock V3 Series
Product ID
0x0001
Lock
The Device specific report returns the 6 byte long DMI serial number of the host.
Notification CC V8 (secure)
The Notification CC is implemented as a push only, which means only pushes notification to the controller.
Sequence number is not supported.
Supported notifications
Notification Type
Event
Comments
Access Control
(0x06)
Manual Lock Operation (0x01)
User Touch button used to lock the door.
Manual Unlock Operation (0x02)
User Touch button used to unlock the door.
RF Lock Operation (0x03)
Bluetooth or Z-wave initiated the operation
RF Unlock Operation (0x04)
Bluetooth or Z-wave initiated the operation
Auto Lock Locked Operation(0x09)
The Auto Latch time has locked the door. Not
used. Auto locks sends (0x01) instead.
Lock Jammed (0x0B)
The lock/unlock operation could not be
completed.
Power Level CC V1 (secure & unsecure)
Can be used under inclusion to test signal strength from the controller and to the device.
Security CC V1 (secure & unsecure)
See Z-Wave documentation.