Step-By-Step Instructions
Replacing a Tub Spout is an easy project that you can definitely handle yourself. It’s a great way
to upgrade the look of your bathroom or to repair a spout that has seen better days. There are
several different types of Tub Spouts. Here we are going to detail how to replace a ½” Copper Pipe
Slip Connection, which is the most popular type of connection. For other connections, be sure to
follow the manufacturer’s directions for installing your Tub Spout.
Tools and supplies required: Phillips Screwdriver, Flat Head Screwdriver, Adjustable Pliers,
Fine Gauge Sandpaper
1
Turning counterclockwise, remove the old Tub Spout. If your Tub Spout has a set screw holding
it in place, be sure to remove that prior to rotating the Spout off. If your Tub Spout is hard to
remove, you may need to use the end of a hammer or large wrench to help loosen while turning.
Just insert the handle into the opening of the Tub Spout for leverage.
2
Measure the Stub Out Nipple length from the wall surface to the end of the Pipe. The Stub Out
Nipple must be between 2” and 3” long. The end of the Stub Out Nipple should be even.
To Next Page
Need help?
General
