6.3. Controls and indicators
6.3.1. Mains power switch
The on/off rocker switch [8] is located on the top left of the rear
panel.
OFF
Mains isolation is not provided. The internal power
supplies are off but stay connected to the mains.
ON The unit is switched on and ready for operation.
6.3.2. RESET (System reset)
A reset button (RESET [9]) is located on the rear panel between
the INPUT A2 and INPUT A3 connector terminals. To prevent
accidental system reset, the button is slightly countersunk.
To perform a system reset, proceed as follows:
Note: All device preferences will be set to factory defaults
except for the network (CAN/Ethernet) and fixed device
settings.
1. Switch off the device.
2. Press and hold the RESET button using an appropriate pen
and repower the device.
↳
Long confirmation beep.
3. Release the button and briefly press the button again within
2 sec.
↳
Short confirmation beep. The device will boot up.
Further details on the different reset functions are described in
Þ Chapter 12.5.1.3.1. "System reset" on page 52.
d&b 10D/30D Manual 1.10 en 19
To Next Page
Loading...
