12.4. Remote
Selecting the «Remote» tab allows you to assign remote settings for
both Ethernet and CAN remote control.
12.4.1. IP settings
Selecting the navigation field «IP settings» enters the corresponding
subscreen. In addition, the IP mode is displayed at the bottom right
of the navigation field.
IP address
IP mask
IP gateway
Selecting either field opens the numerical input
mask and allows you to enter the relevant
data.
Wrong entries can be corrected by clicking the
Erase button ( ) on the bottom right.
Clicking «OK» on the top right confirms the
entry, closes the input mask and switches back
to the Remote screen.
Clicking the Back button (
) on the top left
cancels any entry and switches back to the
Remote screen keeping the previous entry.
IP mode
Selecting this field enables the following
settings:
Manual
Allows the manual assignment of IP settings.
DHCP+FB
When the device is connected to a network
with a DHCP server present, a matching IP
address is assigned automatically.
If no DHCP server is present on the network,
the IP will fall back (FB) to the manual IP
addressing. If a DHCP server becomes
available later, an IP address will be
automatically assigned later.
d&b 10D/30D Manual 1.10 en 49
To Next Page
Loading...
