13.4. EQ - Equalizer
Selecting «EQ» opens the equalizer subscreen of the respective
channel.
The graphic opposite shows the location of the equalizer (User
EQ) within the signal chain.
The equalizer provides two independent and user definable 16-
band equalizers (2 x 16 minimum phase biquad IIR filters, full
parametric) and is split into two layers:
Þ EQ overview,
Þ EQ layer/curve.
EQ overview
The upper part of the overview provides the overall frequency
response of all filters while «EQ 1» is displayed in red and «EQ 2»
in yellow.
Active filters are displayed by continuous lines and the curves are
filled with grey color while inactive filters are displayed by dashed
lines.
The bottom part of the overview provides the following functions:
EQ [n]
On/Off
Master On/Off switch for the respective EQ.
On the Home screen, the On/Off status of the
equalizer is indicated by the entry «EQ» on the
«Channel view» button of the corresponding
channel strip, as shown in the graphic
opposite.
Edit Opens the corresponding subscreen (EQ
layer/curve) for editing.
Clear... Resets all filter settings of the corresponding
EQ.
To prevent accidental reset when you click the
«Clear...» button, a dialog will pop up
prompting you to confirm the reset or cancel
the sequence by clicking the Back button ( ).
Copy/Paste
Allows the entire EQ settings of one channel to
be copied/pasted to any other channel.
To do so, proceed as follows:
d&b 10D/30D Manual 1.10 en 63
To Next Page
Loading...
