13.5. DLY - Delay
An independent signal delay is available for each channel to allow
delay settings of up to 10000 ms/10 sec (3440 m/11286 ft).
DLY
On/Off
Switches the delay on or off without affecting the
entered delay values. Set to "On" the applied value
will be set right away.
Value The delay time is adjustable from 0.3 to 10000 ms
in steps of 0.1 ms or a corresponding value
depending on the units selected.
Unit Enables selection of the delay units, either
milliseconds [ms], meters [m], feet [ft] or seconds [s].
A change in the units will be applied to all channels.
On the Home screen, the "On" status of the delay is indicated by
the set value and unit on the Channel view button of the
corresponding channel strip, as shown in the graphic opposite.
13.6. Input routing
Selecting «Input routing» opens the corresponding subscreen.
The input sources can be selected individually per amplifier
channel or pair of amplifier channels (depending on the output
mode setting).
Analog and digital inputs can be combined.
The Input routing screen also provides direct access to the
Þ «Input mode» screen.
d&b 10D/30D Manual 1.10 en66
To Next Page
Loading...
