The integrated Web Remote interface provides direct access to the
user interface of a single amplifier using a standard web browser.
Note: The user interface of the amplifier can only be
accessed after connecting the amplifier to a computer via
Ethernet. It is possible to connect the computer and the
amplifier directly, however, this requires to manually set static
IP addresses.
Recommended and tested browsers
Windows: ▪ Firefox V22.0 or higher
▪ Microsoft Internet Explorer V11 or higher
▪ Microsoft Edge V12 or higher
▪ Google Chrome V21 or higher
▪ Opera V15 or higher
macOS: ▪ Safari V6.0 or higher
▪ Firefox V22.0 or higher
▪ Google Chrome V21 or higher
▪ Opera V15 or higher
iOS: ▪ iOS 6 or higher
Android: ▪ Mobile Firefox V27.0 or higher
▪ Android Browser V4.4 or higher
Physical setup
Simply connect the LAN connector port of your computer to the
ETHERNET 1 connector [4] of the amplifier.
Direct connection
By factory default, the amplifier's IP addresses are set to:
10D:
192.168.1.10
30D: 192.168.1.30
To access the amplifier, manually assign an IP address to the
computer in your network in the same subnet as the amplifier.
Proceed as follows:
1. Navigate to the network settings of your computer associated
with your network adapter.
2. Open the corresponding network properties dialog.
3. Enter a static IP address in the same subnet as the amplifier:
IP address:
e.g. 192.168.1.11
Subnet mask: 255.255.255.0
4. Confirm the changes and close the network properties dialog.
5. To display the Web Remote interface page of the amplifier,
enter its IP address in the address bar of your web browser.
↳
192.168.1.10 (10D)
192.168.1.30 (30D)
7. Initial configuration
d&b 10D/30D Manual 1.10 en 21
To Next Page
Loading...
