d&b audiotechnik 30D - User Interface Concepts; Operating Concept and Cursor Conventions

8.1. Operating concept
The operating concept allows two different methods of interaction
and configuration:
1. Navigation and configuration via the integrated Web Remote
interface using a standard web browser.
Mainly intended for Þ Initial configuration of a single
amplifier.
2. Configuration and operation as well as firmware updates of
multiple amplifiers via Ethernet (OCA) or CAN-Bus using the
d&b Remote control software R1 V2.
Cursor conventions
The graphical user interface features two types of cursors, the
Position and the Edit cursors.
Position
cursor
The Position cursor marks the selected Menu item by
a white frame. Depending on the type of screen
item, the Position cursor allows you to either activate
a function, navigate through the menu or enter Edit
mode Þ Edit cursor.
Edit
cursor
In Edit mode, the Edit cursor is marked by a yellow
frame.
To leave Edit mode click the respective Menu item
again. The color of the frame will change from
yellow back to white again Þ Position cursor.
8.1.1. Web Remote interface
Web Remote interface page
The Web Remote interface page is split into four tabs: the
«Web Remote», «Event log», «Commands» and «Service» tabs.
Web Remote tab
The «Web Remote» tab shows the user interface of the connected
amplifier.
All screens and screen items can be accessed by simply clicking
the relevant item.
Edit
For applicable parameters, the «Edit» button becomes
accessible and a corresponding dialog will pop up.
8. User interface
d&b 10D/30D Manual 1.10 en22