12.3. Output
Selecting the «Output» tab allows you to assign the appropriate
Output mode to a pair of amplifier output channels (AMP A/B
and/or AMP C/D).
The following Output modes can be assigned to a pair of amplifier
output channels (AMP A/B and/or AMP C/D).
▪ Dual Channel
▪ Mix TOP/SUB
▪ 2-Way Active
▪ Mixed configurations
Þ
A change of the Output mode must be confirmed. This is done
by selecting either the Back ( ) or the Home ( ) button.
↳
The set Output mode will be activated and the
corresponding channels will be muted.
Note: Changing the Output mode directly affects the
available range of loudspeaker setups.
On the Home screen, the selected Output mode is displayed in the
header area below the device name.
The channel strips below the Header section change depending on
the chosen modes as shown below.
2 x Dual Channel
2 x Mix TOP/SUB
2 x 2-Way Active (30D only)
Mixed configuration
On the bottom left of the Output screen, the «Speaker» navigation
button provides direct access to the Þ Speaker setup screen.
d&b 10D/30D Manual 1.10 en46
To Next Page
Loading...
