DS labels
Selecting the «DS labels» button opens the «DS labels» subscreen.
In connection with d&b DS devices, meta data such as Dante
channel labels and cabling information are sent via the AES3
outputs alongside the digital audio samples using the AES3 User
bits.
These meta data can be read out by the amplifier and displayed
on this screen. The screen is split into three columns and the
following information is provided for each of the digital inputs
D1 - D4:
D[n] PRI SEC Out [n]/[n+1]
Tx label@Tx Device
DS device name
DS rx label
D [n] The corresponding input.
PRI/SEC Indicates wether the Primary and/or
Secondary Dante Audio Network is running
(green - ) or interrupted (gray - ).
Tx label@
Tx Device
The Dante channel that is received at this
amplifier input.
DS device
name
The name of the DS device connected to this
amplifier input via AES3.
DS rx label The configured Dante receive channel label for
the DS output which is connected to this
amplifier input.
Out [n]/[n+1] The physical DS output connected to this
amplifier input.
Example
A simple example is shown in the graphic opposite. The stream
labels are stated in inverted commas. The corresponding labels
and their locations on the screen are listed in the table below.
D1
PRI SEC Out 1/2
Main R@FoH
DS10 Stage R
Front - Output 1
d&b 10D/30D Manual 1.10 en 67
To Next Page
Loading...
