13.8.1. ArrayProcessing
Usually ArrayProcessing (AP) data are generated within the
ArrayCalc software and transferred to the amplifiers via the d&b
Remote network (OCA) using R1.
However, once the ArrayProcessing data have been transferred to
an amplifier remotely, each data slot may also be accessed
locally.
AP slot Selection field for each memory slot.
Note: The first slot (1) is reserved as a
bypass slot.
Below the selection field, the slot name and
version are displayed together with the
comment for the slot that was previously
entered in ArrayCalc.
In addition, the selected slot is indicated on the
respective channel strip on the «Home» screen.
Clear all slots Resets all slot data.
HF Trim (HFT)
As part of the ArrayProcessing feature, the HF Trim (High
Frequency Trim) option allows you to trim the HF of a processed
array due to changing air absorption conditions in the far field
areas during a show.
The «HF Trim» option only becomes accessible when the «AP»
setup of the relevant cabinets is loaded. HF Trim can be activated
from the respective channel screen and can be set locally or via
the d&b Remote network using R1. However, HF Trim will usually
be applied for grouped cabinets within R1.
Off
No additional target distance.
+1/+2 10% (+1) or 20% (+2) additional target distance for
each source.
The compensation is limited to an absolute additional
distance of 30 m (100 ft).
On the Home screen, the On/Off status and the setting of the
HF Trim option is indicated by the entry «HFT[n]» on the
«Channel view» button of the corresponding channel strip, as
shown in the graphic opposite.
d&b 10D/30D Manual 1.10 en72
To Next Page
Loading...
