Startup
5.2.4 ETHERNET (Dual Ethernet port)
NOTICE!
Only shielded network cables (STP) must be used!
The device allows standard remote control via the d&b Remote
network using the d&b R1 Remote control software or the
integrated Web remote interface.
For this purpose, use the upper RJ45 (ETHERNET 1/PRI)
connector socket (1 Gbit/s/100 Mbit/s – peer-to-peer) requiring
star topology network wiring. Daisy-chaining is not supported.
Note: The bottom RJ45 connector socket (ETHERNET 2/SEC)
is not enabled but is reserved for future feature implementations.
LED indicators
The two LED indicators above the respective connector in use
indicate the following states:
Green
Illuminates permanently when the device is connected
to an active network and flashes as long as a data
stream is transmitted.
Yellow ▪ Is off when the speed is 100 Mbit/s.
▪ Illuminates permanently when the speed is
1 Gbit/s.
Star topology
d&b 40D Reference manual 1.3 en 17
To Next Page
Loading...
