Startup
5.4.3 Output
The data section of the Output subscreen provides the following
information:
Note: The values indicated in the graphic opposite do not
correspond to real-world conditions.
1st line Mute status of each channel.
Speaker Loudspeaker setups selected for the
individual channels.
Input Actual input signal levels of the individual
channels.
Output Actual output voltages of the individual
amplifier channels.
GR/
Headrm.
Relationship between headroom (Headrm.)
and gain reduction (GR) with peak hold for
1 sec.
Display ranges:
GR: 0 dB Þ +32 dB.
Headrm.: –32 dB Þ 0 dB.
Impedance Actual load impedance values for the
individual amplifier channels.
Power Power actually delivered by the individual
amplifier channels.
Temperature Actual temperatures of the individual
amplifier channels.
ISP/OSP Indicates whether the input signal (ISP) as
well as the amplifier output signal (OSP) of
the individual channel are present.
GR/OVL Indicates whether gain reduction (GR -
Yellow) of the respective channel is active or
the respective channel is overloaded (OVL -
Red).
Mains/SMPS
Displays the actual mains voltage and
frequency followed by the actual power
consumption of the power supply.
In addition the actual temperature of the
power supply is indicated.
5.4.4 Network
The data section of the Network subscreen provides the following
information:
Mode:
Actual IP mode.
IP:
IP mask:
IP gateway:
Actual IP settings.
MAC: Displays the fixed MAC address of the
device.
Status: Provides status information on the network.
Remote ID Unique Remote identifier of the respective
device in the format [nn].[nn].
The first two digits represent the Subnet.
Within the network up to 100 subnets can be
defined (values 0 to 99).
d&b 40D Reference manual 1.3 en22
To Next Page
Loading...
