d&b audiotechnik 40D - Device Configuration; Initial Device Setup; GPIO Configuration

Device configuration
6.1 Initial device setup
The device is mainly intended to be set up and operated via the
d&b Remote network using the d&b R1 Remote control software.
Provided R1 is already installed and the device has been
connected either directly or through the network, proceed as
follows:
Þ
From the startup menu, choose the «R1 V3 Initial device setup»
entry.
↳
R1 is launched and automatically switches to «Online»
mode and the «Service» view is displayed.
In the left pane of the view, the connected device is listed.
In the right pane, the corresponding
«Filter» Þ «Initial device setup»
is set by default and provides you with basic parameters (in
alphabetical order) to set up the device.
6.2 GPIO Configuration
1. To configure the GPIOs, switch R1 to «Configuration»
mode.
2. From the «System views» select «Service».
↳
R1 enters the «Service» view with the «Interfaces» tab being
active.
3. Select the «Devices» tab.
↳
In the right pane of the «Service» view the «Properties»
tab becomes accessible
4. From the «Filter» drop-down list select «GPIOs» or
«Initial device setup»
↳
The table will become accessible indicating the GPI/GPO
states and providing the related parameter function and
mode.
6 Device configuration
d&b 40D Reference manual 1.3 en 25