Web Remote interface
In addition, a Web Remote interface is integrated which provides
direct access to the user interface of a single amplifier using a
standard web browser.
Note: The user interface of the amplifier can only be accessed
after connecting the amplifier to a computer via Ethernet. It is
possible to connect the computer and the amplifier directly,
however, this requires the IP mode DHCP+LL.
The use of a router with DHCP server is recommended for
setting up the network connection. If the router also provides a
wireless access point, the amplifier may also be controlled using
mobile devices.
Recommended and tested browsers:
Windows:
▪ Firefox V22.0 or higher
▪ Microsoft Internet Explorer V11 or higher
▪ Microsoft Edge V12 or higher
▪ Google Chrome V21 or higher
▪ Opera V15 or higher
macOS: ▪ Safari V6.0 or higher
▪ Firefox V22.0 or higher
▪ Google Chrome V21 or higher
▪ Opera V15 or higher
iOS: ▪ iOS 6 or higher
Android: ▪ Mobile Firefox V27.0 or higher
▪ Android Browser V4.4 or higher
Remote control
To enable remote control via the Web Remote interface, proceed
as follows:
1. Establish a connection between the network connector of the
amplifier and the router.
↳
After a while, the «Remote» tab of the amplifier screen will
display the IP address the DHCP server has assigned to the
device.
2. Type this address into the address field of the browser or the
mobile device that is connected to the network.
↳
In this case: 10.5.2.78
3. For multiple amplifiers, open one browser tab for each
amplifier connected and apply the corresponding IP address.
Web Remote interface page
The Web Remote interface page is split into four tabs: the
«Web Remote», «Event log», «Commands» and «Service» tabs.
Web Remote tab
The «Web Remote» tab shows the actual screen of the connected
amplifier.
All screens and screen items can be accessed by simply clicking
the relevant item.
7 Web Remote interface
d&b 40D Reference manual 1.3 en28
To Next Page
Loading...
