Index
Figures used in the manual
Fig.# Titel
Page
Fig. 1: D12 Amplifier.....................................................................8
Fig. 2: D12 amplifier block diagram........................................8
Fig. 3: D12 Controls and indicators.......................................13
Fig. 4: D12 Mains power switch..............................................13
Fig. 5: D12 Controls....................................................................13
Fig. 6: D12 Indicators in detail.................................................15
Fig. 7: D12 Connections............................................................17
Fig. 8: D12 Mains panel............................................................17
Fig. 9: Pin assignment for remote control (RJ45)................18
Fig. 10: SERVICE connector (D-SUB-9)..................................18
Fig. 11: D12 I/O Panel..............................................................19
Fig. 12: D12 Signal input connectors.....................................19
Fig. 13: Pin assignment D12 INPUT/LINK.............................19
Fig. 14: D12 EP5 [16a] or NL4 [16b]
output connectors.......................................................................19
Fig. 15: D12 Input/Output routing Dual channel mode
with standard input routing......................................................20
Fig. 16: D12 Input/Output routing Mix TOP/SUB mode
with standard input routing......................................................20
Fig. 17: D12 Input/Output routing 2-Way Active mode
with standard input routing......................................................20
Fig. 18: D12 I/O Configurations.............................................22
Fig. 19: D12 Cooling airflow....................................................23
Fig. 20: Average maximum total output power vs.
ambient temperature.................................................................25
Fig. 21: D12 front view..............................................................28
Fig. 22: D12 rear view...............................................................28
Fig. 23: D12 enclosure dimensions in mm [inch].................28
Fig. 24: D12 mains panel..........................................................28
Fig. 25: D12 I/O panel EP5......................................................28
Fig. 26: D12 I/O panel NL4.....................................................28
Tables used in the manual
Tab.# Titel
Page
Tab. 1: D12 amplifier, Scope of supply...................................7
Tab. 2: Voltage ranges 115/230 V........................................11
Tab. 3: Voltage ranges 100/200 V........................................11
Tab. 4: RJ45 pin assignment on d&b devices......................18
Tab. 5: D-SUB-9 pin assignment on d&b devices..............18
Tab. 6: TOP/SUB pin assignments EP5/NL4 connectors..21
Tab. 7: D12 Power balance......................................................24
Tab. 8: Mains supply and number of devices.....................25
D12 Amplifier, Hardware manual (2.0E) Index - 1/Page 30 of 32
To Next Page
Loading...
