Preset Name
Enables the assignment or editing of a Preset Name (maximum 15
characters):
1. Selecting the "Preset Name field" enters the sub-menu and the
cursor is positioned at the beginning of the field.
2. Pushing the encoder enters edit mode. The pointer, (
), indicates the
entry position for new or edited characters. A variety of characters
(e.g. capital and lower case letters, numbers 0-9 and special
characters) is displayed in the bottom line.
3. By turning the encoder, each character can be highlighted. Turning
left moves the cursor to the beginning of the list (A ⇐), turning right
to the end of the list (⇒ @).
4. By pushing the encoder, the highlighted letter is entered in the upper
line and the pointer advances one place.
5. Repeat steps 1 to 4 until the complete device name is entered.
6. Exit edit mode by moving the cursor to the return sign (
) and
pushing the encoder.
Notes:
An existing entry can be completed by the return sign at any position.
Succeeding letters are deleted automatically.
Single characters can be kept by simply pushing the encoder, the
pointer advancing one place after each entry.
The editing position can be scrolled through the characters by pushing
and turning the encoder simultaneously.
Ok
Selecting "Ok" and pushing the encoder will confirm the new setting
and exit the sub-menu.
Cancel (⇒ Back
)
Exits the sub-menu leaving the previous name installed.
Remote
Mode
Selecting "Mode" the following modes for remote control are available:
off: no remote control.
RIB/TI212: remote control according to TI212 (Basic remote and
RIB Remote. (indicated as "
” in the main screen)
Note:
Selecting the "RIB/TI212" mode (Basic remote) the D12 will be switched
into standby mode. The D12 now can be switched on by applying an
permanent DC voltage of 18 to 28 V to pin 7 (+) and 8 (-) of one of
the remote connectors (RJ 45). Please refer to section 4. Remote control
& monitoring on page 34.
RIB: remote control via d&b RIB/ROPE.
(indicated as "
" in the main screen)
Note:
Control via d&b RIB only in conjunction with the d&b ROPE 2.0 or
ROPE 3 remote software.
RIB/RS232: remote control via RS232 and the SERVICE connector
of the D12. (indicated as "
" in the main screen)
D12 Software manual (Firmware V2.x.x) (5.2EN) Page 20 of 36
To Next Page
Loading...
