d&b audiotechnik D12 - Lock

dbCAN: remote control via dbCAN (CAN-Bus)/ROPE C.
In 2-Way Active mode indicated as "
CAN
" and the "
dbCAN Id" e.g.
7.63
in the main screen.
In Dual channel or Mix Top/Sub mode indicated with
the "dbCAN Id" e.g.
7.63
in the main screen.
dbCAN Id
Setting the "dbCAN identifiers [n].[nn]". The first digit represents the
CAN sub net. Eight sub-nets can be defined (values 0 to 7). Using the
two digit device ID for each sub-net 63 devices can be defined (values
01 to 63).
Lock
Selecting "Lock" and pushing the encoder enters the sub-menu.
Lock now
Pushing the encoder switches the device into "Lock" mode according to
the mode selected below and exits the sub-menu "Lock". In 2-Way
Active Mode a locked device is indicated by "
" in the Main screen.
Mode
Selecting "Mode" and pushing the encoder toggles between two
options to protect the device against unintentional operation.
Press 2s: prevents accidental operation by locking the front
panel controls.
Password: password protection that prevents operation by
unauthorized persons.
Show
Selecting "Show" and pushing the encoder allows two different screens
to be displayed when the device is locked.
Main Screen: switch to the "Main screen".
Levels Screen: switch to the "Levels screen".
Selecting "Password" and pushing the encoder enters the sub-menu
"Edit Password".
D12 Software manual (Firmware V2.x.x) (5.2EN) Page 21 of 36
Lock Press 2s
Password
Lock
Back
Lock now
Mode Press 2s
D12 Stage right
J12
-3.0dB
-3.0dB
HFC
LFC
EQ
0.01
Active
0.3ms
D
CAN
C -5
Sub net 0 to 7
Device Id 01 to 63
dbCAN Id 7. 01
dbCAN Id 0. 01
dbCAN Id 7. 63
dbCAN Id 7. 01
Show Main Screen