Edit Password
Enables the input of a new, or editing of an existing password
(maximum 7 characters).
Note:
Factory (default) password DBAUDIO.
1. Selecting "Password" enters the "Edit Password" mode and the
cursor is positioned at the beginning of the "Password".
2. Pushing the encoder enters edit mode. The pointer (
), indicates the
entry position for new or edited characters. The selection of
characters (Capital letters) is displayed in the bottom line.
3. By turning the encoder, each character can be highlighted. Turning
left moves the cursor to the beginning of the list (A ⇐), turning right
to the end of the list (⇒ Z).
4. By pushing the encoder, the highlighted letter is entered into the
password line and the pointer advances one place.
5. Repeat steps 1 to 4 until the complete password is entered.
6. Exit edit mode by moving the cursor to the return sign (
) and
pushing the encoder.
Notes:
An existing entry can be completed by the return sign at any position.
Succeeding letters are deleted automatically.
Single characters can be kept by simply pushing the encoder, the
pointer advancing one place after each entry.
The editing position can be scrolled through the characters by pushing
and turning the encoder simultaneously.
Ok
Selecting "Ok" and pushing the encoder will confirm the new setting
and exit the sub-menu "Password".
Cancel (⇒ Back
)
Exits the sub-menu leaving the previous password installed.
Unlocking the device
An attempt to change the status of the device in "Lock" mode will be
met by the message "Unlock: Press knob 2s" being briefly displayed.
Unlock the device as follows:
Press 2s
Push and hold the encoder for a minimum of 2 seconds until the
message "Unlock: Press knob 2s" disappears from the first line of the
LCD.
Password
Push and hold the encoder for a minimum of 2 seconds until "Please
Enter Password" is displayed. The password is entered as described
above under "Password". An incorrectly entered password will revert
the device to the screen selected for "Lock" mode.
Notes:
If the password had been lost a protected D12 can be released through
a System-Reset (See Section 2.6 System Reset on page 32).
Options
The "Options" menu allows further settings and status retrieval in
addition to the operational configurations and parameters of the
device.
D12 Software manual (Firmware V2.x.x) (5.2EN) Page 22 of 36
To Next Page
Loading...
