2.5.4 Further messages
The following messages are for information on the status of the D12.
They are no error messages.
Standby: Indicates the device is in standby mode.
Unlock: Press knob 2s: indicates that the device has been locked
to protect it against accidental or unauthorised operation. Push and
hold the encoder for a minimum of 2 seconds until "Lock" disappears
from the lower status line of the LCD.
2.6 System Reset
Note:
Following a system reset operation all user settings of the device will be
lost except the "dbCAN Id".
- Switch off the unit.
- Push and hold down the MUTE A switch while switching on the power
supply to the unit again.
The following "Reset screen" will be displayed:
All Settings have been
reset to factory defaults
Press A again to reboot
dbCAN active Id 0.01
- Release the MUTE A switch and press the MUTE A switch again
The unit will restart and is ready for operation.
D12 Software manual (Firmware V2.x.x) (5.2EN) Page 32 of 36
To Next Page
Loading...
