Startup
5.2 Connections
5.2.1 Mains connection
WARNING!
Potential risk of electric shock or fire.
The device is a protective class 1 unit. A missing earth (ground)
contact may cause dangerous voltages in the housing and controls
and may lead to electric shock.
▪ Connect the device to mains power supplies with protective
earth only.
▪ If there is any sign of obvious damage to the power cord
and/or mains plug, do not use the power cord and replace it
before further use.
▪ Please ensure the mains connector is accessible at any time to
disconnect the device in case of malfunction or danger.
If the mains plug is not readily accessible due to mounting in a
19" rack, then the mains plug for the entire rack must be readily
accessible.
▪ Do not connect or disconnect the mains plug under load.
Before connecting the device to mains voltage, check that the
mains voltage and frequency correspond to the specifications on
the rating label next to the mains connector socket on the rear
panel of the unit.
Mains voltage range:
100 to 240 V AC, ~50/60 Hz, 1800 W.
A powerCON
®
TRUE 1 TOP mains connector socket [1] is fitted
on the rear panel and an appropriate power cord [1.1] is
supplied.
d&b D40 Reference manual 1.5 en 15
To Next Page
Loading...
