Device setup
6.3 Output
NOTICE!
Ensure that the connected loudspeaker type corresponds to the
actual output configuration of the amplifier.
See chapter Þ Chapter 5.2.3 "SPEAKER OUTPUTS" on page 17
for the wiring of the power amplifier channels to the output sockets.
Select the «Output» tab to assign the output mode to a pair of
amplifier output channels (AMP A/B and/or AMP C/D).
The following output modes can be assigned to a pair of amplifier
output channels (AMP A/B and/or AMP C/D).
▪ Dual Channel
▪ Mix TOP/SUB
▪ 2-Way Active
▪ Mixed configurations
Þ
A change of the output mode must be confirmed. This is done
by selecting either the Back (
) or the Home ( ) button.
↳
The set output mode is activated and the corresponding
channels are muted.
Note: Changing the output mode affects the available range
of loudspeaker setups.
On the home screen, the selected output mode is displayed in the
header area below the device name.
The channel strips below the header section change depending on
the chosen modes as shown below.
2 x Dual Channel
2 x Mix TOP/SUB
2 x 2-Way Active
Mixed configuration
On the bottom left of the Output screen, the «Speaker» navigation
button provides direct access to the Speaker setup screen.
6.4 Network
Select the «Network» tab to assign remote settings for Ethernet
remote control.
d&b D40 Reference manual 1.5 en30
To Next Page
Loading...
