Device setup
6.4.1 IP settings
Select the navigation field «IP settings» to enter the corresponding
subscreen. In addition, the «IP mode» is displayed on the upper
right of the navigation field.
IP mode Selecting this field enables the following
settings:
Manual
Allows the manual assignment of IP settings.
DHCP+FB
When the device is connected to a network
with a DHCP server present, a matching IP
address is assigned automatically. If no DHCP
server is present on the network, the IP will fall
back (FB) to the manual IP addressing.
DHCP+LL
IP mode for using Link-Local addressing.
When a DHCP server is present, the IP address
is assigned automatically by that server. If this
fails, an address will be assigned
automatically using the Link-Local address in
the range from 169.254.0.1 to
169.254.255.254. All devices in a local
network will ensure that their IP addresses are
unique. After the Link-Local configuration is
completed, a fully functional network will be
available. If a DHCP server is available later,
an automatic IP will be automatically assigned
later.
Link-Local addressing is the default behavior of
every PC and MAC computer when no DHCP
server is present. The DHCP+LL setting enables
the amplifier to also work in a setup without a
DHCP server. A fully functional local network
including remote control from a PC or Mac via
R1 will be set up automatically.
Note: Please note that IP addresses in the
Link-Local range (169.254.0.0/16) cannot
be assigned manually.
IP address
IP mask
IP gateway
Provided the IP mode is set to «Manual»,
selecting either field opens a numerical input
mask and allows you to enter the relevant
data.
Wrong entries can be corrected by tapping
the erase button ( ) on the upper right.
Select «OK» on the top right to confirm the
entry, close the input mask and switch back to
the «Network» screen.
Select the back button (
) on the top left to
cancel any entry and switch back to the
«Network» screen keeping the previous entry.
Set gateway
to default
When this button is selected, the gateway
address is derived from the IP address and IP
mask settings.
d&b D40 Reference manual 1.5 en 31
To Next Page
Loading...
