Device setup
MAC: Displays the fixed MAC address of the device.
Status: Shows which of the etherCON connectors is
connected (busy).
Provides status information on the network:
< 1 Gbit/s
= 1 Gbit/s
6.4.2 Remote ID
Select the «Remote ID» button to set the unique remote identifier of
the respective device in the format [nn].[nn].
Subnet
The first two digits represent the subnet.
Within an Ethernet network up to 100
subnets can be defined (values 0 to 99).
Note: In case of a subnet mismatch, the
following message is issued at the bottom
of the screen:
Remote ID exceeds 99.63
Device ID Using the two digit Device ID for each subnet,
you can define a total of 63 devices (values 1
to 63).
6.5 More
Selecting the «More» tab provides further subscreens such as:
▪ Preferences
▪ Info
▪ Levels
▪ Mains current limiter
▪ ...
6.5.1 Preferences
Select «Preferences» to open the corresponding subscreen with the
«Display» tab being active.
d&b D40 Reference manual 1.5 en32
To Next Page
Loading...
