Device setup
6.5.1.1 Display
The «Display» tab provides the following display options.
Backlight
Enables the following optional settings:
Off The display brightness is set to 1 (minimum
brightness).
On The backlight is permanently on.
Timeout
10s
Illuminates the display when you press the
encoder or select the display. The light switches off
automatically 10 seconds after the last operation.
Note: This setting is recommended to increase
the lifetime of the display.
Brightness
Adjusts the display brightness in the range from 1 to 10. The
default setting is 8.
Touch beep
Enables or disables the beep sound when using the touch screen.
Touchscreen calibration
Due to mechanical impact or the aging process of the touch
screen, its calibration references may change.
An indication is that when you tap a specific button and the
adjacent button is activated instead or when a specific button does
no longer work.
In such cases, the touch screen should be recalibrated.
To calibrate the touch screen, proceed as follows:
1. Select «Touchscreen calibration».
↳
The Screen calibration menu will open guiding you through
the calibration process.
2. Follow the relevant on-screen instructions.
6.5.1.2 Lock
Select the «Lock» tab to open the corresponding subscreen which
provides different protection settings.
Mode
Select «Mode» to toggle between two options to protect the
device against unintentional operation.
Press knob 2s
Prevents accidental operation by locking the
front panel controls.
Password Password protection to prevent operation by
unauthorized persons.
Screen
Select «Screen» to allow two different settings for the screen when
the device is locked.
Home screen
Switches to the Home screen.
Levels Switches to the Levels screen.
d&b D40 Reference manual 1.5 en 33
To Next Page
Loading...
