Device setup
Edit password
Select the «Edit password» option to open an input mask which
enables you to edit or assign a password (upper-case characters
with a maximum length of 7 characters).
Wrong entries can be corrected by tapping the Erase button on the
bottom right (
).
Tap «OK» on the top right to confirm the entry, close the input
mask and switch back to the lock screen.
Tap the back button (
) on the top left to exit the input mask and
leave the previous password unchanged.
Note: The factory default password is: dbaudio
Lock
Tap the «Lock» button to confirm any new settings and exit the
subscreen. A corresponding message is displayed.
The device will be switched to the screen selected for lock mode.
Unlocking the device
If you attempt to change the status of the device while it is in lock
mode, the following message will be issued: Press encoder for 2s
to unlock. To unlock the device, proceed as follows:
Press ...
Press and hold the encoder for a minimum of 2
seconds until the message disappears.
Password 1. Press and hold the encoder for a minimum of
2 seconds until the corresponding input mask
is displayed.
2. Enter the password as described above.
An incorrectly entered password will revert the
device to the screen displayed for Lock mode.
If the password is lost or forgotten, a locked device can be
unlocked by performing a system reset.
Note: All device preferences will be set to factory defaults
except for the network (Ethernet) and fixed device settings.
If you execute this procedure, no dialog will be prompted and
the reset will start immediately.
To perform a system reset, proceed as follows:
1. Switch off the device.
2. Press and hold the encoder and repower the device.
↳
Long confirmation beep.
3. Release the encoder and briefly press the encoder again
within 2 sec.
↳
Short confirmation beep.
The device will boot up and will switch to the home screen.
A corresponding message will be issued:
d&b D40 Reference manual 1.5 en34
To Next Page
Loading...
