d&b audiotechnik GmbH R70 operation and configuration
3.4. LAN network with DHCP server
Note: If a firewall is active, allow access to the UDP Port 33333 (fix)
and the TCP Port 30000 (adjustable).
The "Obtain an IP address automatically" function is enabled by default.
1. Connect the R70 to your network and an IP address is
assigned by the DHCP server.
2. Start the respective d&b software (e.g. R1 - Edit mode) and
select "CAN" from the "Extras-Options" menu.
The program scans for connected interfaces and all devices
found are listed. This may take several seconds.
3. Right click on an R70 entry in the list and select
"Configure Interface" to access the R70 web interface.
(1.4 EN) Page 13 of 20
To Next Page
Loading...