Danelectro DADDY O - Danelectro Daddy O. DO-1: Instructions and Controls; Connecting and Powering the Pedal; Control Knob Functions; Battery and Power Options

3
60’sBRITISHCRUNCH
CONTROL SETTINGS
VOL
BASS
MID
TREB
O. DRIVE
2
Connect instrument cable to the IN jack. Connect amplifier
cable to the OUT jack. If using Danelectro AC Adaptor,
connect to DC 9-Volt jack. (Use only a 9-Volt adaptor for
this unit, not 18-Volt).
LED light will be on when foot switch is activated.
Control Functions:
VOL: This control sets the level of output to the
amplifier.
BASS: Controls the gain of the bass frequencies.
MID: Controls the gain of the mid frequencies.
TREB: Controls the gain of the treble frequencies
O. DRIVE: Use this control to set the amount of overdrive.
DADDYO. OVERDRIVE
DO-1 INSTRUCTIONS
•
•
•
BATTERY: Uses one S-006P 9-Volt Battery. Danelectro “Vintage Power Source”
batteries are recommended.
Battery Eliminator: Uses 9-Volt battery eliminator. Polarity: Center negative (–).
300mA maximum.
TM
All manuals and user guides at all-guides.com