To Next PageTo Next Page
Need help?Do you have a question about the Danfoss AKC 114 and is the answer not in the manual?
General| Supply voltage | 24 V AC/DC |
|---|---|
| Frequency | 50/60 Hz |
| Display | LED |
| Hysteresis | Adjustable |
| Application | Refrigeration |
| Type | Electronic controller |
| Voltage | 24 V |
| Sensor Type | NTC |
Details product identification numbers and general information.
Describes the basic principle and mounting concept of the device.
Details specifications for sensor cable length and wire gauge.
Guidance on sensor placement and the need for insulation.
Specifies the operating voltage range for the device.
Information regarding single-phase power supply configurations.
Detailed instruction for placing sensor S1 on the evaporator passage.
Diagram and explanation of sensor terminal connections.
Detailed definitions for each sensor (S1-S6) based on application.
Details on connecting the device to a 230V AC power supply.
Description of each terminal's function for various connections.
Wiring diagram and instructions for electric defrost using DEF.A output.
Wiring diagram and component list for gas defrost operation.
Information on connecting AKA 14/15 display units to the controller.
Explanation of data signal transfer between controllers and cable installation importance.
Setting the BUSTERM switch for units transferring or receiving data signals.
Instructions for setting the address code and mains frequency.
Explanation of status indicators for Open, Closed, OK, and ALARM.
Specifies the type and rating of the spare fuse.
