Danfoss ECL Comfort 296 - Holiday Program

8 | © Danfoss | 2016.02 VI.KT.Y2.02 VI.KT.Y2.02 © Danfoss | 2016.02 | 9
6.0 Holiday program
There is a holiday program for each circuit and a
common holiday program for all circuits.
Each holiday program contains one or more
schedules. It can be set to a start date and an end
date. The set period starts on the start date at
00.00 and stops on end date at 24.00.
The end date must be at least one day later than
the start date.
The holiday program in the 'Common
controller settings' is valid for all circuits.
The holiday program can also be set
individually in the heating or DHW circuits.
How to set your holiday schedule:
Action: Purpose: Examples:
Choose 'MENU'
Conrm
Choose the circuit selector at
the top right corner in the
display
Conrm
Choose a circuit or 'Common
controller settings'
Conrm
Go to 'Holiday'
Conrm
Choose a schedule
Conrm
Conrm choice of mode selector
Choose mode:
• Comfort
• Comfort 7-23
7-23
• Saving
• Frost protection
Conrm
Enter start time rst and then
the end time
Conrm
Go to 'MENU'
Conrm
Choose ‘Yes’ or ‘No’ in ‘Save’.
Choose the next schedule, if
required