69
www.Daniel.com
USER MANUAL
Important
The security latch prevents the removal of the LME cover in a flameproof
environment.
3. Unscrew the end cap and remove it from the housing.
4. Unplug one or two ¾-14 NPT ports (as required) and install the conduit (provided by
the customer) to the enclosure and tighten.
5. Install the electronics according to Wiring and cable connections. Consult with
Daniel if the preamplifier acquired is other than a dual channel preamplifier.
WARNING
SHOCK AND EXPLOSION HAZARD
Verify that the LME and/or RME is grounded.
Failure to comply may cause death, serious injury and/or equipment damage.
6. Screw the end cap to the housing. Hand-tighten, only if required.
7. Install the security latch.
User manual Installation procedure
P/N 3-9008-515 March 2019
User manual 75
To Next Page
Loading...
Need help?
General