ENGLISH
OPERATION MANUAL
CAUTION! Do not keep the keys in the safe itself!
1. OPENING THE SAFE FOR THE FIRST TIME
To open the safe for the first time, remove the small central rubber cover “Z”
(see picture 1) between knob and keypad, insert the key into the lock and turn
it counter-clockwise, at the same time, turn the doorknob clockwise and open
the door.
2. INSTALLING THE BATTERIES
The safe requires 4 pieces size “AA” (1.5V) batteries.
The batteries compartment “Y” (see picture 2) is located on the back of the
door. Remove the battery cover and install the batteries into the compartment.
Ensure the batteries are fitted with the correct corresponding polarity.
Once the batteries are installed, close the battery compartment.
3. PROGRAMMING THE CODE
A. Remove the battery cover and press the red button “X” inside the battery
compartment (see picture 2), release it and you will hear two beeps.
B. Press on the front display from 3 to 8 numbers that you wish to use as a
combination and confirm by pressing the button “B” within 15 seconds. Or
To Next Page
General